16 bay SATA RAID
16 bay SATA RAID
|
| 16 bay base SCSI 160 host to SATA drive RAID system (optional NAS). Rack or tower |
$6700.00 |
| 16 bay SCSI 160 host to SATA drive raid system. User will configure drives and raid level in options section. After third drive you can add empty trays. |
|
Must add to cart to get final cost and shipping. You can make
configuration and cost changes in cart . |
RAID Enclosure - Including sixteen (16) half height removable drive trays, pull handles, 64Mb Cache two (2) hot swap 300W power supplies, Two (2)hot swap fans, fan fault detection, 16 SATA Channels,Dual Ultra3 Host to SATA RAID Controller
Exclusive RAIDm monitoring and notification software provides instant access to the status of the RAID Array and allows for 24x7 RAID monitoring and notification.
Dual host connection can support two hosts simultaneously. Perfect for clustered environments, e.g. MSCS - Microsoft Cluster Server.
Up to sixteen low-profile Serial ATA disk drives.
RAID controller provides RAID 0, 0+1, 1, 3, and 5, Global Hot Spare Disk, Auto Rebuild, and up to 512 MB of SO-DIMM SDRAM-based data cache.
Intelligent SATA backplane design (uses no cables) allows "hot swapping" of disk canisters, power supplies, and fans for increased reliability, lower cost, and ease of maintenance.
In-band SCSI monitoring and fault notification to fax / pager or e-mail.
Completely user configurable via the front panel.
Lightweight aluminum chassis design.
Environmental Monitor module allows observation of critical operating parameters via the front LCD panel.
Built-in Ethernet Interface for remote configuration and management with SNMP support
General
RAID Architecture
64-bit RISC 100MHz CPU with 100MHz memory bus
Up to 800 Mbytes/sec internal bandwidth
Dual PCI bus architecture
Host Bus Interface
Two, 160 MB/sec. Ultra3 LVD (Low Voltage Differential) SCSI
Disk Bus Interface
Sixteen 1.5 Gb PHY Serial ATA Interface channels;
48-bit addressing
Command Queuing
253 commands (host SCSI channels)
Cache
Up to 512 MB (using one, industry-standard 144 pin 133MHz SO-DIMM SDRAM)
ECC function is supported by the RAID controller
Operating Systems Supported
Windows Server 2003, Windows 2000 and MSCS (Microsoft Cluster Server), Windows NT, Sun/Solaris, Linux, Tru64 Unix, HP/UX, IBM AIX, SGI IRIX, DEC VMS, MAC OS, FreeBSD, Novell, OS/2, and others to be announced
Environmental
Temperature
50°F to 104°F operating, -40°F to +140°F non-operating 10°C to 40°C operating, -40°C to +60°C non-operating
Relative Humidity
10% to 85% non-condensing (operating), 5% to 90% non-condensing (non-operating)
Certifications
FCC, CE, TUV, and UL/CSA
Physical
Size/Weight
19" wide, 20.5" deep, 5.25" (3U) high; 40 lb. / 18 kg. (without disk drives)
I/O Connectors
Four 68-pin high density SCSI;
Three 9-pin DB9 type RS-232 serial terminal port, fax / pager port, UPS port;
RJ45 Management Port / Ethernet
Power Required
110 or 220 VAC, ±20% @ 3 amps peak; 47 to 63 Hz. autosensing
Three independent power inputs
|
|
