When configuring your SCSI controller to operate properly with your tower, you will need to adjust some bios options from the controller card. Typically your SCSI controller has been configured from the factory to support a Hard Disk. Cdrom's are not as fast as Hard Drives, so the controller needs to be tuned down to work properly with the slower devices.
| 1. |
Whatever the current Sync Transfer rate is, set it to 10mbps. |
| 2. |
Wide and Sync negotiation should be turned off. |
| 3. |
PARITY CHECKING should be turned off. |
| 4. |
If you are using a Nakamachi mini changer, make sure to turn Multiple LUN support on. |
©1998, 1999, 2000 JES Hardware Solutions All Rights Reserved.