To install the firmware you will need at least one work-station
running TCP/IP
Now that you have the most current firmware downloaded.
Note: do not type the [ ] brackets in the instructions below, only what is between them and then press [enter].
| 1. |
Shell out to a DOS prompt, and change to the same directory where the firmware file is located. |
| 2. |
Open an ftp session by typing the following, [ftp the address of the controller]. |
| 3. |
When asked for a user name and password type [admin] for both. |
| 4. |
Type, [binary] to switch into binary mode. |
| 5. |
Type, [put dzimg403.bin DiscZerverImage]. |
Make sure you capitalize the first letter of each word. When the upgrade is complete the controller will automatically close the connection and reset the controller. When the status light on the controller goes green, you are now back up and running.
All of the network and security settings will remain intact, only the firmware is updated.
©1998, 1999, 2000 JES Hardware Solutions All Rights Reserved.